E P ARMORY ADAPTABLE AR15 STICKER JIG

0 Review(s)

Your Price: $3.99

Retail Price:$6.99

You Save:$3.00(43%)

Out of Stock.

Part Number:STICKER-JIG

Description
Customer Reviews

When purchasing this product you will receive a sticker decal jig completion set. (one set includes the top, left, right, and inner decal)
These stickers are made of high quality vinyl decal material. They do not leave any residue and come off clean.

This is a Universal Stackable Decal Jig for an AR15 Lower Receiver.
This jig can help you complete your EP 80 Lower as well as any other 80 percent lower that you may have.
This sticker decal jig works well on aluminum as well as polymer lowers for any brand and any company.
We created this jig to mill spec down to 1/100 th of an inch.

This AR 15 sticker decal jig can also be used as a mil-spec checker for your current AR 15 rifles.
Use this jig to make sure that your rifle is perfect and in spec to the industry and military standards.

(DIRECTIONS)

Apply side stickers using the sharp 90* corners and the circle to surround the taker down pins for both sides.
Apply top plate sticker using the front flat edge along the outer bolt catch lever pocket.
Using a colored sharpie, wax or paint pen color in the hole marking that are needed for drilling
Remove the sticker jig and affix back to the wax side of jig packaging.
Center your drill bit in the marked are and drill from each side one at a time. (DO NOT DRILL STRAIGHT THROUGH)
Top depth is 1.25 inches from top of EP80-2
Trigger slot can be cut by using a 3/8 drill bit or mill bit and 1/2in long centered from the trigger pin.
After machining and drilling is complete install LPK and function check for fitment. If LPK does not function check your depths and or drill marks with sticker jig again.