The newest in E P Armory innovation.
This Kevlar reinforced
polymer is able to take GLOCK magazines and run pistol calibers 9mm or
40S&W. The EP80-G has steel inserts for ejector pin and extraction
rigidity. We also expanded our design to handle the recoil that blow
back operation has opposed to DI rifles. Be sure to know your
rifle/Pistol and run E P Armory quality components in correct placement
will ensure a lasting enjoyment of the build. Whether your waning to
make a AR pistol, AR rifle or the perfect truck gun we have you covered.
THIS PRODUCT INCLUDES:
- EP80-G 80% lower receiver
- Extractor (not installed)
will need to purchase a glock style magazine release (NOT INCLUDED)
component, stock or pistol buffer tube setup, Lower parts kit to
complete this lower.
back operation does cause severe recoil opposed to standard AR gas
system. You must use a 5.6oz or higher buffer to maintain a
manufacturers warranty for breaking. Don't use cheap parts and expect
- 40 S&W
- 45ACP- not yet available
- 10MM- not yet available
BEFORE EXTRACTOR INSTALLATION:
- Machine the pocket and holes for installation of the LPK.
- Test fit all components of the LPK for proper function.
INSTALLATION OF THE EXTRACTOR:
- Use heavy duty epoxy and set extractor in place
the extractor in place and draw line on extractor. Remove the extractor
and align on side for the holes to be marked by sharpie or pen. Drill
small 3/32 holes for pin installation. Apply epoxy, install the
extractor and install pins through the extractor. Allow curing time.
FITMENT OF EXTRACTOR:
on the BCG used for the build some fitting may be needed. Now that a
few manufacturers have multiple bolts on the market you need to plan for
some more possible fine tuning. There are Glock BCG's, Colt BCG's, HK
BCG's and combo BCG's. The Glock bolts if a true fit should work with
minimal if any fine tuning. All others may need some fitment to clear
the carrier grooves and or mag lip.